Friedrich C24YJ Manuale Utente Scaricare il pdf (Pagina 48)

- 48 -

Only for training and service purposes

• Confirm that the vertical louver is normally geared with the shaft of Stepping Motor.

• If the regular torque is detected when rotating the vertical louver with hands ⇒ Normal

• Check the connecting condition of CN-U/D or CN0L/R Connector

• Check the soldering condition(on PCB) of CN-U/D or CN0L/R Connector

Check the operating circuit of the vertical louver

• Confirm that there is DC +12V between pin ¿ of CN-U/D, CN0L/R and GND.

• Confirm that there is a soldering short at following terminals.

- Between 1 , 2 , 3 and 4 of MICOM - Between

and

of MICOM

- Between 4 , 5 , 6 and 7 of IC01M - Between 5 , 6 , 7 and 8 of IC01M

6.5 When the louver does not operate.

If there are no problems after above checks.

•

Chec

k that no objects are catching and interfering parts in the link of the vertical louver

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 89 90

Nessun commento

Friedrich C24YJ Manuale Utente Pagina 48